jpandza
Forum Replies Created
-
Hi Megan,
Please see screenshot below. After opening the capstone for the first time, I run the setup command and use the scratchpad as suggested, then I proceed with the first couple of questions, but when I finally get to connecting to port 5010, the connection is refused. Then I open a new tab, choose the terminal option and enter this to see if 5010 is in use. I assume there’s an additional command I must have missed or failed to execute before. Thanks,
Jaka
-
Hi Megan,
After following your steps and running the code in scratchpad, I was still met with the “Blocked” error message on a simple calculation.
